A practical reference on purity percentage: what it is, how it behaves, what the literature reports, and where the honest uncertainties sit.
Reviewed 2026-07-21. Anything still debated is marked as such rather than presented as settled.
Other methods address specific purity concerns. Amino acid analysis gives compositional data after hydrolysis, while capillary electrophoresis separates by charge-to-mass ratio. Karl Fischer titration measures residual water, and gas chromatography can detect residual solvents. Nuclear magnetic resonance can identify organic impurities but is less sensitive for trace levels. No single test covers all possible impurities, so purity testing usually combines orthogonal methods and reports the conditions used. The choice of methods is guided by the impurity classes of interest.
Reverse-phase high-performance liquid chromatography (RP-HPLC) is widely used to estimate peptide purity. It separates components by hydrophobicity on a column with a water-organic mobile phase. Ultraviolet absorbance at 214 nm or 220 nm detects peptide bonds. The main peak area as a percentage of total peak area gives a purity figure. This figure depends on column, gradient, wavelength, and how peaks are integrated, so it is method-specific rather than absolute.
Reported purity values can differ between laboratories even for the same sample. Variations arise from column chemistry, mobile-phase composition, gradient slope, detection wavelength, injection load, and integration rules. Area percent also assumes that all species have similar response factors, which is not always true. Method validation examines specificity, linearity, accuracy, precision, limit of detection, and limit of quantitation. When comparing certificates, the method description and representative chromatogram are as important as the headline percentage.
Purity and potency are related but distinct concepts in peptide testing. Purity describes the proportion of the main peptide relative to other detected substances, while potency refers to the biological or functional activity of a defined amount. A highly pure peptide can still have low potency if it is misfolded, aggregated, or chemically modified at a critical residue. Conversely, a less pure preparation may retain high activity if the impurities are inactive. Clear reporting separates these attributes and states the assay used for each.
| Property | Value | Notes |
|---|---|---|
| Typical analytical method | RP-HPLC with UV detection | Separates by hydrophobicity; purity is method-dependent |
| Confirmatory method | LC-MS or MALDI-TOF MS | Provides molecular mass and impurity mass information |
| Common detection wavelength | 214 nm or 220 nm | Peptide bond absorbance; also 280 nm for aromatic residues |
| Typical purity specification | 95% or greater by HPLC area | Common research grade; exact threshold depends on application |
| Sample preparation | Dissolve in water/acetonitrile with acid | Formic acid or trifluoroacetic acid often used |
The predecessor of modern countercurrent chromatography theory and practice was countercurrent distribution (CCD). The theory of CCD was described in the 1930s by Randall and Longtin. Archer Martin and Richard Laurence Millington Synge developed the methodology further during the 1940s. Finally, Lyman C. Craig introduced the Craig countercurrent distribution apparatus in 1944 which made CCD practical for laboratory work. CCD was used to separate a wide variety of useful compounds for several decades.
Much of the genetic manipulation done in CHO cells is done in cells lacking DHFR enzyme. This genetic selection scheme remains one of the standard methods to establish transfected CHO cell lines for the production of recombinant therapeutic proteins. The process begins with the molecular cloning of the gene of interest and the DHFR gene into a single mammalian expression system. The plasmid DNA carrying the two genes is then transfected into cells, and the cells are grown under selective conditions in a thymidine-lacking medium. Surviving cells will have the exogenous DHFR gene along with the gene of interest integrated in its genome. The growth rate and the level of recombinant protein production of each cell line varies widely. To obtain a few stably transfected cell lines with the desired phenotypic characteristics, evaluating several hundred candidate cell lines may be necessary. The CHO and CHO-K1 cell lines can be obtained from a number of biological resource centres such as the European Collection of Cell Cultures, which is part of the Health Protection Agency Culture Collections. These organizations also maintain data, such as growth curves, timelapse videos of growth, images, and subculture routine information.
For vitamin B12, the U.S. Recommended Dietary Allowance (RDA) for pregnancy is 2.6 μg/day, for lactation 2.8 μg/day. Determination of these values was based on an RDA of 2.4 μg/day for non-pregnant women, plus what will be transferred to the fetus during pregnancy and what will be delivered in breast milk. However, looking at the same scientific evidence, the European Food Safety Authority (EFSA) sets adequate intake (AI) at 4.5 μg/day for pregnancy and 5.0 μg/day for lactation. Low maternal vitamin B12, defined as serum concentration less than 148 pmol/L, increases the risk of miscarriage, newborn low birth weight and preterm birth. During pregnancy the placenta concentrates B12, so that newborn infants have a higher serum concentration than their mothers. What the mother-to-be consumes during the pregnancy is more important than her liver tissue stores, as it is recently absorbed vitamin content that more effectively reaches the placenta. Women who consume a small percentage of their diet from animal-sourced foods or who by choice consume a vegetarian or vegan diet are at higher risk than those consuming higher amounts of animal-sourced foods of becoming vitamin depleted during pregnancy, which can lead to anemia, and also an increased risk that their breastfed infants become vitamin deficient.
Years after the conference, people ascribed a large amount of significance to it. According to Paul Berg and Maxine Singer in 1995, the conference marked the beginning of an exceptional era for both science and the public discussion of science policy. The guidelines devised by the conference enabled scientists to conduct experiments with recombinant DNA technology, which by 1995 dominated biological research. This research, in turn, increased knowledge about fundamental life processes, such as the cell cycle. Additionally, the conference, along with public debates on recombinant DNA, increased public interest in biomedical research and molecular genetics. For this reason, by 1995, genetics and its vocabulary had become a part of the daily press and television news. This, in turn, stimulated knowledgeable public discussion about some of the social, political, and environmental issues that emerged from genetic medicine and the use of genetically modified plants in agriculture. Another significant outcome of the conference was the precedent it set about how to respond to changes in scientific knowledge. According to the conference, the proper response to new scientific knowledge was to develop guidelines that governed how to regulate it.
Sources: en.wikipedia.org
Depending on the column size, CIM monolithic columns are primarily used for the purification or analysis of large biomolecules which are being used for cancer gene therapy, treatment of viral infectious diseases and treatment of genetic diseases. Some types of molecules that can be successfully purified using CIM columns are pDNA, IgM, inter-alpha inhibitors, virus like particles, and diverse viruses; adenoviruses, bacteriophages, feline calicivirus, hepatitis A, lentivirus, influenza A and B, rabies virus, rotavirus, tomato and pepino mosaic virus. Since 2004, BIA Separations has organized and hosted the Monolith Summer School and Symposium (MSS) which takes place every 2 years. MSS was established as there were no dedicated conferences to this technology and to bring together the top international scientists and researchers in the area of monolith chromatography to share their experiences and innovative applications. BIA Separations home page Monolith Events
Ca2+ currents through cardiomyocyte gap junctions mediate synchronized contraction of cardiac tissue. As a result, GCaMP expression in cardiomyocytes, both in vitro and in vivo, has been used to study Ca2+-influx-dependent excitation and contraction in zebrafish and mice. For instance, Tallini et al. (2006) expressed GCaMP2 in mouse embryos to show that, at embryonic day 10.5, electrical conduction was rapid in the atria and ventricles but slow in the atrioventricular canal. Chi et al. (2008) used a transgenic cardiac-specific GCaMP zebrafish line to image cardiomyocyte activation throughout the cardiac cycle; from their results, they characterized four developmental stages of the zebrafish cardiac conduction system and identified 17 novel mutations affecting cardiac conduction. However, uncontrolled expression of GCaMP leads to cardiac hypertrophy due to overexpression of the calmodulin motif, which interferes with intracellular calcium signaling. As a result, experiments using cardiac tissue should carefully control the level of GCaMP expression.
The main function of motilin is to increase the migrating myoelectric complex component of gastrointestinal motility and stimulate the production of pepsin. Motilin is also called "housekeeper of the gut" because it improves peristalsis in the small intestine and clears out the gut to prepare for the next meal. A high level of motilin secreted between meals into the blood stimulates the contraction of the fundus and antrum and accelerates gastric emptying. It then contracts the gallbladder and increases the squeeze pressure of the lower esophageal sphincter. Other functions of motilin include increasing the release of pancreatic polypeptide and somatostatin.
Sources: en.wikipedia.org
It usually refers to the relative area of the main peak in a chromatographic separation, such as RP-HPLC. It estimates the proportion of UV-absorbing material in that peak, not the absolute mass fraction of the target peptide. Different methods can give different percentages.
HPLC separates and quantifies components, while mass spectrometry identifies molecular masses. Together they can show whether a main peak has the expected mass and whether other peaks correspond to related peptide variants. This combination is more informative than either method alone.
Higher purity reduces the proportion of detectable related impurities, which can matter for research reproducibility. However, purity value alone does not establish identity, biological activity, or safety. The appropriate purity depends on the intended use and the sensitivity of the assay.
Purity percentages vary because each laboratory uses its own column, mobile phase, gradient, detection wavelength, and integration settings. A 95% value from one method may not equal 95% from another method. Comparative assessment requires the same validated procedure or an orthogonal cross-check.